Click on Start, stand in the T-pose for 2-3 seconds, play the movement we want to record.Open iPi Studio -> New project -> select the video you just recorded -> Calibration project -> calibrate based on 3d plane -> Wait -> Scene -> Save Scene.It is necessary to move the cardboard in different directions, while its surface should be visible from both sensors. Click on Start, get up and hold the cardboard so that it is visible from each sensor.Next, the program analyzes the background, in the field of view of the sensors should be only stationary objects.Launch iPi Recorder, select 1-2 kinekta as a recording device.Important: if you change the position of the sensors, you will need to re-calibrate them. It is necessary that they be as few as possible. Important: yellow on the depth map means that the sensor cannot distinguish depth at these points. in length (1 - 1.5 m is recommended.) The calibration surface should be clearly visible from each sensor. The angle between the sensors is 110-180 degrees:įor calibration, use a cardboard / board with a size of 0.5 m.The angle between the sensors is 30-90 degrees:.Sensors can be located in 2 configurations: In order to receive MoCap data from 2 sensors, it is necessary to record video for calibration. You can read more about this on the wiki ipisoft instructions for the old version of the program, in the latest version the configuration is a little different. Install iPi Studio and iPi Recorder, connect Kinect. In this article I will tell you how to animate a character using MoCap data obtained using ipi mocap studio and 2 Kinect sensors.Īutodesk Motionbuilder 2013 is better, but I use 2012, because 2013 does not work for me
0 kommentar(er)
